Microe 1500V Mercury Manuale Utente Scaricare il pdf (Pagina 10)

Installation Instructions

Rotary Encoders - Using Alignment Tool - Mounting

Attach your hub/scale

assembly to the rotary

device. Refer to the

interface drawing. The

reflective surface of the

scale must face the sensor.

1

Page 8

3

Be sure the source power is off

before connecting the SmartPrecision

Alignment Tool. (The M1500V-AC

Atmospheric Cable shown above is

optional. A customer-supplied cable

may be used.)

Connect the M1500V encoder to the

SmartPrecision Alignment Tool.

2

To M1500V encoder

To Power Supply

4

Connect the Alignment Tool to the

Computer Interface Adapter. Turn on

the power.

Install the sensor on your mounting surface

referencing the appropriate datum surface as

shown on the interface drawing. Use 2 washers

per mounting screw.

Benching pins may be used to locate the sensor

if the system mechanical tolerances are adequate.

See data sheet for alignment tolerances, or keep

mounting screws loose for sensor alignment if

benching pins are not used.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Commenti su questo manuale

Nessun commento